| |
CA6140A |
CA6240A |
CA6150A |
CA6250A |
CA6161A |
CA6261A |
| Swing over bed |
400 mm |
500 mm |
610 mm |
| Swing over carriage |
210 mm |
300 mm |
370 mm |
| Swing over gap×Width in gap |
- |
630 mmX210 mm |
- |
720 mmX210 mm |
- |
830 mmX210 mm |
| Max. workpiece length/Max. cutting length |
750/650 mm 1000/900 mm 1500/1400 mm2000/1900 mm |
| Distance between spindle center line and plane guide |
205 mm |
250 mm |
305 mm |
| Spindle bore/Taper in front of spindle |
φ52 mm/Morse No.6 |
| Steps of spindle speed Forward/reverse |
24/12 |
| Range of spindle speed |
Forward |
50Hz:11-1600r/min 60Hz:12-1680r/min |
| |
Reverse |
50Hz:14-1580r/min 60Hz:16.8-1896r/min |
| Range of longitudinal feed(64 kinds) |
Standard feed0.08-1.59mm/r Standard feed0.028-0.054mm/r
Feed increase0.86-3.16mm/r |
| Range of feed(64 kinds) |
Standard feed0.04-0.79mm/r Standard feed0.014-0.027mm/r
Feed increase0.86-3.16mm/r |
| Longitudinal/cross rapid speed |
Longitudinal4m/min, Transverse2m/min |
| Cutting range of thread |
44 metric thread 1-192mm Modulus Thread 390.25-48mm British Thread 212-24Dental / inch Drive Festival Thread 371-96 |
| Max. travel of top & lower slide |
140mm/320mm |
140mm/420mm |
| Rotating angle of turret |
±90° |
| Distance between spindle center line and supporting surface of tooling |
26 mm |
| Sectional size of shank |
25mm×25mm |
| Diameter & travel of sleeve of tailstock; Taper of sleeve bore |
75mm×150mm Morse No.5 |
| Pitch of leadscrew |
12mm |
| Power of main motor |
7.5 kW |
| Net weight (Approximately) |
750mm |
1990 kg |
2060 kg |
2180 kg |
1000mm |
2070 kg |
2140 kg |
2260 kg |
1500mm |
2220 kg |
2290 kg |
2437 kg |
2000mm |
2570 kg |
2640 kg |
2787 kg |
| Dimensions(L×W×H) |
750mm |
2418×1000×1267 mm |
2418×1037×1312 mm |
2418×1130×1367 mm |
1000mm |
2668×1000×1267 mm |
2668×1037×1312 mm |
2668×1130×1367 mm |
1500mm |
3168×1000×1267 mm |
3168×1037×1312 mm |
3168×1130×1367 mm |
2000mm |
3668×1000×1267 mm
|
3668×1037×1312 mm |
3668×1130×1367 mm |
